Comtech EF Data HPOD Installation And Operation Manual page 96

HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier
Serial-Based Remote Product Management
Command
Parameter Number of
(Instruction
Type Arguments
& Qualifier)
Reference REF= 3 bytes,
Oscillator numeric
Tuning
Retrieve N/A 22 bytes,
Equipment alphanumeric
Type
RF Power FET N/A variable length
Current status depending on
the number of
FETs installed in
the amplifier
Description of Arguments
Command or Query.
Adjusts the reference oscillator tuning voltage by sending a DAC value in the form xxx, where:
xxx = numeric value from 0 to 255, and the default value is set to 87.
Example:
<1/REF=87'cr'
>0001/REF=
Note: This command sets the DAC value, but the actual Reference Oscillator tuning voltage can be
monitored using the RMS command.
Query only.
Returns the Model Number and the version of the MnC firmware installed in the unit.
Example:
<1/RET?'cr'
>0001/RET=CPA-300 VER: 1.0.3'cr''lf'
Query only.
Returns all the FET currents.
Example:
<1/RFS? 'cr'
>0001/RFS='cr'
Q01=xx'cr'
Q02=xx'cr'
Q03=xx.x'cr'
Q04=xx.x'cr'
Q05=xx.x'cr'
Q06=xx.x'cr'
Q07=xx.x'cr'
Q08=xx.x'cr'
Q09=xx.x'cr'
Q10=xx.x'cr'
Q11=xx.x'cr'
Q12=xx.x'cr'
Q13=xx.x'cr'
Q14=xx.x'cr'
Q15=xx.x'cr'
Q16=xx.x'cr''lf'
5–16
Revision 6
MN/HPOD.IOM
Query
Response to
(Instruction Response to Query
Command
& Qualifier)
REF= REF? REF=xxx
REF?
REF* (See Description of
Arguments)
N/A RET? RET=x....x
(See Description of
Arguments)
N/A RFS? RFS=x....x
(See Description of
Arguments)