Jams inside a tray after clearing the metal stop
The print media jams as it releases from under the metal stop, but it has not completely exited the
tray. This can occur in any of the trays. You need to check each tray.
1
Pull the tray completely out.
2
Reposition the print media under the metal stop.
Note: If the sheet of print media is damaged, remove it. Do not reposition it.
3
Press down on the print media until the metal plate below it locks into place.
4
Insert the tray. See
tray.
5
Press
.
Clearing jams
Page 63
in
Loading print media
Jams inside a tray after clearing the metal stop
for an illustration of how to insert the
97