SECTION 3
CAL-IOM-2012-1220
FIGURE 10 SAMPLE SCREEN OF SOLA CONTROL
CHANGING THE OPERATING SET POINT
From the main screen do the following:
1. Tap "Con gure. "
2. Tap "Central Heat Con guration. "
3. Tap "CH Set Point. "
4. Tap "Clear. "
5. Enter New Set Point.
6. Tap "OK. "
7. Tap the escape arrow in top right hand corner (see Figure 11).
FIGURE 11 CHANGING THE OPERATING SET POINT
Questions? Call (315) 298-5121, or visit us online at www.fulton.com
OPERATION
!
WARNING
Non-Fulton product information is for
reference purposes only. No Fulton
document should substitute for full
review of documentation available
from the component manufacturer.
4
CAUTION
When making changes to the controls
pro le, a combustion analyzer is
required.
3-5