Product Overview - FULTON Caliber Installation And Operation Manual

INSTALLATION
!
WARNING
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional/professional codes and
regulations.
Operation of this boiler beyond its
design limits or with unapproved
modi cations may result in injury
and/or equipment damage.
Crystalline silica may be present
in components of this equipment.
Exposure to crystalline silica may
pose signi cant health hazards,
including but not limited to eye and
respiratory system damage. Per
the Centers for Disease Control and
Prevention (CDC) and Occupational
Safety and Health Administration
(OSHA), appropriate Personal
Protective Equipment must be worn
to minimize exposure to hazardous
substances. Refer to most current
guidelines o ered by the CDC and
OSHA for more information, including
Personal Protective Equipment
recommendations.
4
CAUTION
This boiler is certi ed for indoor
installation only.
This boiler is not designed for use in
systems where water is continuously
replenished. The warranty is valid for
closed loop systems only.
Fulton cannot be held responsible for
the selection, engineering, installation,
or sizing of any additional equipment
or components of the hydronic heating
system.
A quali ed engineer must be consulted
for equipment selection and heating
system components.
2-2

Product Overview

Prior to the performance of installation, operation, or maintenance procedures,
personnel should become familiar with the equipment (Table 1 and Figure 1) and
its components.
The Fulton Caliber hydronic boiler is an automatic, fuel- red, high-e ciency
boiler. The boiler can either be of the sealed combustion/direct vent type or
utilize conventional combustion air intake and ue methods.
The boiler is capable of sidewall venting when the appropriate venting materials
are used, and when permitted by local code requirements. It features low
emission pre-mix combustion with pulse width modulation and fully automatic
safety controls.
The Fulton Caliber boiler is constructed to ASME Section IV and certi ed by the
Edison Testing Lab (ETL) to Underwriters Laboratories (UL) 795 Issue 2006/10/27
Edition 6 Standard for Safety Commercial-Industrial Gas Heating Equipment. All
Caliber boilers are hydrostatically tested, test red and shipped as a complete
packaged unit. Fuel, water, and electrical connections are similar to other boilers
of this type.
This boiler is to be installed as part of a hydronic heating system. A quali ed
engineer must be consulted for the selection of the equipment and components
of the heating system. Various system conditions can result in incorrect heat
distribution to users of the heating system.
Each Caliber Boiler is supplied with the following:
Lightweight casing utilizing an air gap as insulation
Integrated combustion supervision and temperature operating control
Operating and high temperature dual temperature probe
Low water ow switch
Fully matched modulating premix combustion system including burner,
blower and fuel train controls.
ASME pressure relief valve
Instruction manual
Wiring diagram
Combustion Air Adapter
Temperature and pressure (T&P) gauge
Manual Air Vent
The customer should examine the equipment for any damage. It is the
responsibility of the installer to ensure all parts supplied with the equipment are
tted in a correct and safe manner.
SECTION 2
CAL-IOM-2012-1220
© The Fulton Companies 2012