Inputting Initial System Translations; Adding Media Gateways - Avaya S8500 Installing And Configuring

Chapter 5: IP interface translations

Inputting initial system translations

If the system translations were prepared offsite, enter the translations and reset the media
server. If the translations are not available, enter minimal translations to verify connectivity to
the port networks.
1. After you enter the translations, type save translation and press Enter to save the
translations to the hard disk drive.
2. Type reset system 4 and press Enter to have the software read the copied
translations.

Adding media gateways

Use the Cabinet SAT screen to add media gateways to the system.
Note:
If system translations have been loaded on the media server, media gateways do
Note:
not need to be added to administer the IPSI.
1. Type add cabinet n and press Enter, where n is the cabinet number, for each stack of
media gateways that is controlled by one TN2312BP IPSI circuit pack.
A cabinet is defined as a group of up to five G650 Media Gateways that are mounted in a
rack and TDM-connected.
2. Fill in the carrier location letter and the carrier type for each media gateway in the cabinet.
add cabinet 1
CABINET DESCRIPTION
Cabinet Layout: G650-rack-mount-stack
Number of Portnetworks: 1
Survivable Remote EPN? n
Cabinet Holdover: A-carrier-only
CARRIER DESCRIPTION
Carrier
E
D
C
B
A
60
Installing and Configuring the Avaya S8500 Media Server
Cabinet: 1
Cabinet Type: expansion-portnetwork
Location: 1
Room:
Carrier Type
not-used
not-used
not-used
G650-port
G650-port
CABINET
IP Network Region:1
Floor:
Number
PN 09
PN 09
PN 09
PN 09
PN 09
Page 1 of 1
Building:
June 2006