Chapter 6: IP interface configuration
Setting the VLAN and diffserv parameters
1. Connect to the IPSI and log in as craft.
2. To display the quality of service values, type show qos and press Enter.
3. If necessary, use the following commands to set the VLAN and diffserv parameters to the
recommended values shown.
Note:
Use Help to obtain syntax guidelines for these commands.
Note:
set vlan priority 6
●
set diffserv 46
●
●
set vlan tag on
●
set port negotiation 1 disable
●
set port duplex 1 full
set port speed 1 100
●
4. Type show qos and press Enter to check the administered values.
5. Type quit and press Enter to exit.
!
Important:
Ensure that the port settings on the Ethernet switches are set to the same values
Important:
as shown above in these set port commands. Log in to the Ethernet switch
and type show qos and press Enter.
Resetting the IPSI
1. Connect to the IPSI and log in as craft.
2. Type reset and press Enter and answer Y to the warning.
Note:
Resetting the IPSI terminates the administration session. If further administration
Note:
is required, start a new telnet session on the IPSI.
Note:
The IP address, subnet mask, and gateway control network settings become
Note:
effective when you exit the IPADMIN session.
3. Disconnect the laptop from the IPSIfaceplate.
70
Installing and Configuring the Avaya S8500 Media Server
June 2006