Using The Sat Command Line Prompt - Avaya S8500 Installing And Configuring

Using the SAT command line prompt

Use a direct connection to Communication Manager or a remote Secure Shell (SSH) or Telnet
session to access the SAT command line prompt.
With SSH
To open a SSH session:
See Accessing the command line interface of the server with SSH
With Telnet
To open a Telnet window session:
1. Click Start > Run to open the Run dialog box.
On a direct connection, type telnet 192.11.13.6 and click OK.
●
On a remote connection to the media server, type the IP address of the media server.
●
2. Log in at the prompt.
With Terminal Emulation
To use a command line interface in a terminal emulation window, open your terminal emulation
application. Configure the terminal emulation program port settings as follows:
115200 baud
●
No parity
●
8 data bits
●
1 stop bit
●
No flow control
●
Note:
Avaya Native Configuration Manager, Avaya Terminal Emulation, and
Note:
HyperTerminal are the only terminal emulation programs that Avaya supports.
Use either the IP address or the DNS host name to establish a network connection to the media
server. Use port 5023 for this connection. When prompted, log in.
Installing and Configuring the Avaya S8500 Media Server
Using the SAT command line prompt
on page 99
June 2006
105