Avaya S8500 Installing And Configuring page 68

Chapter 6: IP interface configuration
Depending on the operating system on the Services laptop computer, you might need to clear
the Address Resolution Protocol (ARP) cache before entering a new IP address. If you enter an
IP address and your computer cannot connect, try clearing the cache.
1. On your laptop computer, click Start > Run to open the Run dialog box.
2. Type command and click OK to open a MS-DOS Command Line window.
3. Type arp -d 192.11.13.6 and press Enter to clear the Address Resolution Protocol
(ARP) cache in the laptop.
The command line prompt appears when the cache is cleared.
●
The phrase The specified entry was not found appears when the ARP cache does
●
not contain the specified IP address.
4. To log into the IPSI, type telnet 192.11.13.6 and press Enter.
Prompt = [IPSI]:
Note:
While connected to the IPSI, type help or ? to obtain online help. Most
Note:
commands have two or three letter abbreviations.
5. Type ipsilogin and press Enter.
Note:
The craft login used on the IPSI has a different password from the craft login used
Note:
on the media servers.
6. Log in as craft.
Prompt = [IPADMIN]:
7. Type show control interface and press Enter and then type show port 1 and
press Enter to see the current control interface settings.
68
Installing and Configuring the Avaya S8500 Media Server June 2006