Enabling The Ipsi - Avaya S8500 Installing And Configuring

Enabling the IPSI

Use the IP Server Interface System Parameters SAT screen to enable IPSI circuit pack and
allow the IPSI to control the port network.
1. Type change system-parameters ipserver-interface and press Enter.
2. On the IP Server Interface System Parameters screen, verify that the primary control
subnetwork address is correct.
change system-parameters ipserver-interface
SERVER INFORMATION
Primary Control Subnet Address: 172. 22.
Secondary Control Subnet Address: 192. 11 . 13 .4*
OPTIONS
IPSI Control of Port Networks: enabled
The control subnetwork addresses must match the most significant three octets of the IP
addresses of the server for the media gateway. The most significant three octets are the
first three groups of digits in the IP address. Select the configure server command on
the Maintenance Web Interface to see the IP address of the server.
An asterisk (*) to the right of the Control Subnet Address field means that
Communication Manager does not have the subnetwork information and the subnetwork
address displayed is incorrect.
3. If the information in the Control Subnet Address field is incorrect, use the Maintenance
Web Interface to change the media server configuration to match the Server IP address in
configure server. Under Server Configuration and Upgrades, click Configure Server
to change the media server configuration. Then return to this procedure.
4. Set the Switch Identifier field to the switch ID letter. Acceptable switch ID letters are A
through J. A is the default setting.
5. Set the IPSI Control of Port Networks field to enabled.
6. Press Enter to save the changes.
Installing and Configuring the Avaya S8500 Media Server
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
IPSI Host Name Prefix:
Switch Identifier: A
NOTE: * indicates data changed on the server
Page
0. 0*
Enabling the IPSI
1 of 1
61
June 2006