Table of Contents
Advertisement
S
R
ETTING THE
EMOTE
Your NSP uses the following table when programming your remote control ID to work with each TV in your
household. You may use it, too.
Remote Control ID
0
Local TV1--TV in same room as RG. Remote is set to operate in IR mode.
1
Remote TV1--TV in a different room than the RG.
2
TV2 (remote TV).
3
TV3 (3-stream models only).
To program the remote control ID:
SRC-300A
1. Press the LED key and hold it down until the LED
flashes rapidly.
2. Press the REC key. The LED stops blinking at this point
and stays on solid.
3. Press the A key. The remote is now in programming
mode.
4. Enter the single-digit remote control ID from the table
on page 25.
Valid single-digit codes are 0, 1, 2 (and 3, with 3-stream models).
Note:
If you entered an invalid sequence or a 20-second lapse in button presses occurs, the LED turns off and the
remote control returns to standard operation.
If you correctly entered the single-digit code, the LED flashes on and off and then remains off.
Once you have set the remote control ID, write 0, 1, 2, or 3 on labels and place these labels on the TV and the
remote to help you identify the TV and the remote to which it is assigned. Your Network Service Provider may
have already done this.
Repeat this procedure for each remote control.
P
ROGRAMMING THE
Your Network Service Provider programs each remote control to work with one TV by way of a TV code. The TV
Code is a specific code for each brand and model of TV. When a TV code is set, the remote control is ready to
operate the TV. The TV codes can be programmed manually, or they can be scanned. Each of the methods is
described below.
C
ID
ONTROL
TV C
ODE
Operates TV
1. Press and continue to hold the A button until the LED at
the top of the remote flashes rapidly.
2. Enter the following three-digit sequence: 7-8-9. The
remote is now in programming mode.
3. Enter the single-digit remote control ID from the table
on page 25.
Mode
IR
UHF
UHF
UHF
SRC-200
25
Advertisement
Table of Contents
