Table of Contents
Advertisement
AC O
UTLET
The RG2400 has an AC outlet on the rear of the unit. Other devices can be plugged into this outlet. The outlet is
on when the RG2400 is powered up. If you find that the outlet is off when the RG2400 is on, any press on the
remote control turns the AC outlet back on.
U
Y
R
SING
OUR
EMOTE
The remote control allows you to control TV viewing from anywhere in your home. Your NSP (or yourself) can
program it to operate your TV as well as your RG2400. The remote control operates by sending either IR (infra-
red) or UHF (ultra-high frequency) signals to the RG2400. Your Network Service Provider programs your remote
to operate in the most appropriate mode for your home.
If your remote control is programmed for IR mode, it requires a direct line-of-sight in order to function. In other
words, you need to point an IR remote directly to the television or the RG2400. You can only use an IR remote
to operate a TV that is located in the same room as the RG2400. If your primary TV (TV1) located in a different
room than the RG2400, the remote must be programmed to use UHF mode.
Remote controls that control secondary TVs (TV2, TV3), are also programmed to operate in UHF mode.
R
R
C
EPLACING
EMOTE
Remove the battery compartment cover by holding the remote control with its back facing you, then pressing
1.
the battery cover at the thumb depression and sliding it off.
Install two 1.5V AA alkaline batteries, aligning positive and negative terminals according to the diagrams in
2.
the battery compartment.
Replace the remote control battery cover, snapping it into place.
3.
Press the Power button on the remote control.
4.
R
C
M
EMOTE
ONTROL
ODELS
Two models of remote control can be used with the RG2400. They are the SRC-300A and the SRC-200. To tell
which model you have, consult the label on the back of the remote control. The SRC-300A and the SRC-200 dif-
fer slightly. Both are described in the following sections.
C
ONTROL
B
ONTROL
ATTERIES
13
Advertisement
Table of Contents
