Table of Contents
Advertisement
Follow the steps below to program the TV code when you already know the three-digit code. (For a list of codes,
see
"TV and VCR Codes" on page
SRC-300A
1. Press the LED key and hold it down until the LED
flashes rapidly.
2. Press the REC key. The LED stops blinking at this point
and stays on solid.
3. Press and release the C key. The remote is now in pro-
gramming mode.
4. Enter the three-digit code that corresponds to the brand
name of the TV.
See "TV Codes - SRC 300" on page
41.
If the code is valid, the LED will flash on and off three times and then remain off.
If an invalid code is entered or a 20 second lapse in button presses occurs, the LED will turn off and the remote
control will return to normal operation. You will need to repeat the above procedure to program the TV code.
P
ROGRAMMING THE
To program a TV code by using the search or scan method:
SRC-300A
1. Press the LED key and hold it down until the LED
flashes rapidly.
2. Press the REC key. The LED stops blinking at this point
and stays on solid. (Continue with step 3 below.)
3. Press and release the POWER key. The remote is now in TV code scan programming mode.
4. Press the up key to scan through all TV codes. ** When you reach the correct TV code, the TV will automatically turn
on, or off if it was previously on. Note that the LED will flash rapidly once you have scanned through all the codes, and
then it will continue to go through the codes again in a continuous wrap.
5. Press the SELECT button to store the TV code. The LED flashes rapidly, then stops, indicating that the TV code has
been stored.
6. Repeat procedure for each remote control.
7. If you press the up key too rapidly, you may pass the TV code before the time the TV turns on or off. If you are not
sure you are storing the correct TV code, press the down key slowly to cycle back through codes that have been pre-
viously scanned.
8. When the TV turns off, or on if it was previously off, press SELECT at that point to store the TV code.
26
41.)
TV C
U
C
ODE
SING
1. Press the MUTE button and hold it down until the LED
at the top of the remote control flashes rapidly.
2. While the LED button is flashing, enter the three digit
code that corresponds to the brand name of the TV.
See "TV Codes - SRC-200" on page 43.
S
M
ODE
EARCH
ETHOD
1. Press the MUTE button and hold it down until the LED
at the top of the remote control flashes rapidly.
2. (Continue with step 3 below.)
SRC-200
SRC-200
Advertisement
Table of Contents
