Table of Contents
Advertisement
D
R
ETERMINING THE
Press the LED key for 3 seconds until the LED flashes.
1.
Press the INFO key. The LED stops blinking at this point and stays on solid.
2.
Press the A key and watch the LED.
3.
Following are the sequences of flashing that indicate how your remote control ID is programmed.
•
A short burst of flickering indicates a 0 (zero). A number of longer, steady blinks indicates a non-zero
digit. A zero is the only valid value for use with an RG3000.
•
After blinking, the remote returns to normal operation.
Number of flashes
Rapid flickering
For TV in the same room as your RG3000
(indiactes zero)
a. The RG3000 can only be used with the SRC-300A in IR mode and does not support UHF mode.
S
R
ETTING THE
EMOTE
Your NSP uses the following table when programming your remote control ID to work with each TV in your
household.
Remote Control ID
0
Local TV--TV in same room as RG. Remote is set to operate in IR mode.
a. The RG3000 can only be used with the SRC-300A in IR mode and does not support UHF mode.
To program the remote control ID:
Press the LED key and hold it down until the LED flashes rapidly.
1.
Press the REC key. The LED stops blinking at this point and stays on solid.
2.
Press the A key. The remote is now in programming mode.
3.
Enter the single-digit remote control ID from the table above.
4.
Valid single-digit codes are 0, and 1.
Note:
If you entered an invalid sequence or a 20-second lapse in button presses occurs, the LED turns off and the
remote control returns to standard operation.
If you correctly entered the single-digit code, the LED flashes on and off and then remains off.
P
ROGRAMMING THE
Your Network Service Provider programs your remote control to work with your TV by way of a TV code. The TV
Code is a specific code for each brand and model of TV. When a TV code is set, the remote control is ready to
operate the TV. The TV codes can be programmed manually, or they can be scanned. Each of the methods is
described below.
20
C
ID
EMOTE
ONTROL
Remote Control ID
C
ID
ONTROL
TV C
ODE
a
Operates TV
Mode
IR (Infra Red)
Mode
a
IR
Advertisement
Table of Contents
