Polycom SpectraLink 8020 Administration Manual page 84

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP
84
2. Then, walk the site again, in
checking that every location has adequate coverage (there should
be at least one AP stronger than -70 dBm in all areas) and has
good channel allocation. (At any point, the strongest AP shown
should be on a different channel than the next best choice.)
3. Finally, use the single AP (
ensure it is configured for the proper data rates, beacon interval,
802.11 options enabled, QoS method, and security method.
Make any necessary adjustments to AP locations and configurations
and repeat steps 1 through 3 until the site survey shows adequate
coverage and correct configuration at every location.
The installation is not complete until these certification steps have
been performed. Do not hand out handsets at a site that has not been
certified.
/ ESSID mode, this time
MyID Smry
/ ) display to check each AP, to
MyID Detl
PN: 1725-36038-001_B.doc