Proxy Server Commands - Polycom SpectraLink 8020 Administration Manual

Proxy server commands

Parameter
PROXYn_ADDR
PROXYn _DOMAIN
PROXYn_TYPE
PROXYn_
KEYPRESS_2833
PROXYn_
KEYPRESS_INFO
PROXYn_HOLD_IP0 enable
For up-to-date Asterisk voicemail commands, go to:
2
http://www.voip-info.org/wiki/index.php?page=Asterisk+cmd+VoiceMailMain
PN: 1725-36038-001_B.doc
Use the following parameters when programming the configuration
files. See the sample configuration files following this table for more
detailed information.
Value Description
xxx.xxx.xxx.xxx:pppp Proxy address.
or
proxyname:pppp
Domain name Domain served by this
proxy server.
Specify the
Inter-Tel
manufacturer of each
SER
defined proxy server.
2
Asterisk
enable Controls generation of
disable in-stream RFC2833
formatted key press
events.
enable Controls generation of
disable SIP INFO requests to
the SIP server for
keypress events.
Controls setting of the
disable media stream IP
destination address to
0 (zero) when a call is
put on hold.
Programming the SIP Handset Features
Notes
n = 1, 2, 3
xxx.xxx.xxx.xxx = IP4 address
pppp = port (optional, 5060 is the
default)
proxyname = computer name
(DHCP only)
n = 1, 2, 3
DOMAIN = [example:
spectralink.com]
Can be omitted if the proxy does
not act as a domain server.
Used by the handset to perform
proxy-specific actions based on
known behavior for specific proxy
types. Only the three shown
values may be used. Omit this
parameter if the value is not one
of these recognized settings.
n = 1, 2, 3
n = 1, 2, 3
n = 1, 2, 3
Use for compatibility with older
SIP servers that may not
recognize newer stream attribute
parameters for HOLD status.
51