Polycom SpectraLink 8020 Administration Manual page 69

If you want to...
Change the
ring volume
Adjust the
speaker volume
Adjust the
headset volume
Mute/Unmute a call Press the Mute softkey.
End a call Press the End softkey to maintain the active mode and view the active calls.
Change the profile Press the Prof softkey and use the Nav keys to select a new profile while in
Open Config menu Press the Cfg softkey from standby mode.
Turn on the backlight The backlight comes on when any key is pressed or when there is an incoming
Resume a call on hold
from standby.
PN: 1725-36038-001_B.doc
Then...
Press the up/down volume buttons on the side of the handset during ringing, or
while the handset is in standby mode.
While speakerphone is active, press the up/down volume buttons on the side of
the handset during the call.
While the headset is plugged in, press the up/down volume buttons on the side
of the handset during the call.
When the handset is muted, the audio flowing icon
receive-only icon . Press the Mute softkey again to restore audio pickup.
Press the END key on the keypad to return to the standby mode.
standby mode. The selected profile is marked with an asterisk (*).
call, and stays on for 10 seconds. It turns off if another key is not pressed within
that period.
Press the Resm softkey. If more than one call is on hold, use the Nav
to select the call you wish to resume and press the Resm softkey or NavOK.
Using the SIP Handset
changes to the audio
keys
69