Configuring Load Balance; Load Balance Configuration Example - Zte ZXR10 5900E Series User Manual

ZXR10 5900E Series User Manual (IPv4 Volume)
St- Command
ep
1
ZXR10(config-router)#
bgp<number>}
2
ZXR10(config)#
ding-router's-address>|<interface-name>}[<distan
ce-metric>][tag <tag>]
88 Confidential and Proprietary Information of ZTE CORPORATION

Configuring Load Balance

maximum-paths {<number>|i
ip route <prefix><net-mask>{<forwar
Load Balance Configuration
Example
R1 is connected to R2 over seven links. This is shown in
F 25 LOAD BALANCE CONFIGURATION
IGURE
Static route and dynamic route protocol OSPF is taken as an ex-
ample to describe load balance configuration.
Function
This configures the maximum
number of routers. This
configures the maximum
count of routes in the RIP,
OSPF, IS-IS and BGP route
configuration mode. The
default number of route is 1
and the maximum count is 8.
This configures the load
balance of static route.
This configures multiple static
routes to the same destination
and supports at most eight
routes with different tags.
The default value of the tag
is 3.
Figure 25.