Ospf Maintenance And Diagnosis - Zte ZXR10 5900E Series User Manual

ZXR10 5900E Series User Manual (IPv4 Volume)
St-
Command
ep
1
show ip ospf
ZXR10#
2 show ip ospf interface [<interface-name>][pr
ZXR10#
ocess <process-id>]
3
show ip ospf neighbor [interface <inter
ZXR10#
face-name>][neighbor-id <neighbor>][process
<process-id>]
4 show ip ospf database
ZXR10#
5
show ip route ospf
ZXR10#
6 show ip forwarding subnetrt <ip-address><n
ZXR10#
et-mask>
30 Confidential and Proprietary Information of ZTE CORPORATION
Non-stop Forwarding disabled, last NSF restart 00:14:15 ago (took 0 secs)
Area 0.0.0.1 enable (Demand circuit available)
Enabled for 00:00:12
Area has MD5 authentication
Times spf has been run 1
Number of interfaces 1. Up 0
Number of ASBR local to this area 0
Number of ABR local to this area 0
Total number of intra/inter entries in LSDB 1. Checksum Sum 0x00008e9a
Area-filter out not set
Area-filter in not set
Area ranges count 0
OSPF Maintenance and
Diagnosis
ZXR10 5900E provides show command for maintenance and diag-
nosis.
ZXR10 5900E also provides debug command for maintenance and
diagnosis.
Function
This views OSPF process
detail.
This checks the current
configuration and state of an
OSPF interface.
This checks the information of
OSPF neighbors.
This displays all or part of the
information of the link state
database.
This displays router global
routing table and views if
OSPF route is in routing table.
This views driving hardware
routing table and view if
hardware routing table is
same as global routing table.