Configuring An Igmp Group - Zte ZXR10 5900E Series User Manual

ZXR10 5900E Series User Manual (IPv4 Volume)
Command
ZXR10(config-if-vlanX)#
Command
ZXR10(config-if-vlanX)#
er>
Command
ZXR10(config-if-vlanX)#
[group-list <acl-number>]
70 Confidential and Proprietary Information of ZTE CORPORATION
(NE) in the same network segment to be the IGMP V1 or the IGMP
V2.
For the configuration of IGMP version number of the interface, use
the following command.
ip igmp version <version>

Configuring an IGMP Group

1. To configure group range that allows IGMP to join, use the
following command.
ip igmp access-group<acl-numb
This example shows running of IGMP on the interface. The in-
terface receives all multicast groups by default and sets the
receiving group range on the interface. When the joining re-
quest from the mainframe does not belong to the range discard
the joining request.
Only receive the group 239.10.10.10 on the Vlanl interface.
ZXR10(config)#acl standard number 10
ZXR10(config-std-acl)#rule 1 permit 239.10.10.10 0.0.0.0
ZXR10(config-std-acl)#exit
ZXR10(config)#interface vlan 1
ZXR10(config-if-vlan1)#ip igmp access-group 10
2. To configure the group range permitting the IGMP to leave right
away, use the following command.
ip igmp immediate-leave
Upon receiving the message of the IGMP leaving or not re-
ceiving the Report message within (last member query inter-
valx2+1) seconds then the group members leaves.
In the below configuration the group is permitted 239.10.10.10
to leave right away on the Vlanl interface.
ZXR10(config)#acl standard number 10
ZXR10(config-std-acl)#rule 1 permit 239.10.10.10 0.0.0.0
ZXR10(config-std-acl)#exit
ZXR10(config)#interface vlan 1
ZXR10(config-if-vlan1)#ip igmp immediate-leave group-list 10
3. To configure the static group member on the IGMP interface,
use the following command.
Function
This configures IGMP version.
Function
This configures group range that
allows IGMP to join.
Function
This configures the group range
permitting the IGMP to leave
right away.