Configuring Ospf; Enabling Ospf; Configuring Interface Timer; Configuring Interface Cost - Zte ZXR10 5900E Series User Manual

Command
router ospf <process-id>
ZXR10(config)#
St- Command
ep
1
ZXR10(config-if-vlanX)#
nds>
2
ZXR10(config-if-vlanX)#
<seconds>
3
ZXR10(config-if-vlanX)#
nds>
4
ZXR10(config-if-vlanX)#
nds>
Command
ZXR10(config-if-vlanX)#
When simple password authentication is configured, one interface
can have only one password and each interface can have a differ-
ent passwords all interfaces in a particular network must have the
same password. Simple password is transmitted in plain text by
OSPF packets.

Configuring OSPF

Enabling OSPF

Configuring Interface Timer

ip ospf hello-interval<seco
ip ospf retransmit-interval
ip ospf transmit-delay<seco
ip ospf dead-interval<seco

Configuring Interface Cost

ip ospf cost<cost>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 OSPF Configuration
Function
This enables OSPF routing.
Function
This designates an interval
at which an interface sends
Hello packets.
This designates the interval at
which an interface retransmits
an LSA.
This designates the delay
after which an interface
transmits a LSU packet.
This designates the dead
interval for a neighbor on an
interface.
Function
This configures interface cost.
19