Configuring Is-Is Interface Parameters; Configuring Is-Is Authentication - Zte ZXR10 5900E Series User Manual

Command
ZXR10(config-router)#
net-mask>[metric]< metric-value>[[ level-1| level-1-2|
level-2][metric]< metric-value>]
St- Command
ep
1
ZXR10(config-if-vlanX)#
{level-1|level-1-2|level-2-only}
2
ZXR10(config-if-vlanX)#
<interval>[level-1|level-2]
3
ZXR10(config-if-vlanX)#
<multiplier>[level-1|level-2]
4
ZXR10(config-if-vlanX)#
<interval>[level-1|level-2]
5
ZXR10(config-if-vlanX)#
<interval>[level-1|level-2]
6
ZXR10(config-if-vlanX)#
-1|level-2]
7
ZXR10(config-if-vlanX)#
vel-1|level-2]
8
ZXR10(config-if-vlanX)#
<interval>[level-1|level-2]
5. To summarize entries in IS-IS routing table, use the following
command.
summary-address < ip-address><
Configuring IS-IS Interface
Parameters
Interface IS-IS parameters need to be configures on the interface
running IS-IS.
isis circuit-type
isis hello-interval
isis hello-multiplier
isis lsp-interval
isis retrasmit-interval
isis priority <priority>[level
isis metric <metric-value>[le
isis csnp-interval

Configuring IS-IS Authentication

ZXR10 5900E supports plain text authentication and MD5 encryp-
tion authentication.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 4 IS-IS Configuration
Function
This summarizes entries in IS-IS
routing table.
Function
This designates an operation
types for an interface.
This defines an interval for
adjacent routers hello packet.
This configures isis
hello-multiplier in order
to save time for sending hello
packets.
This sets time interval for
transmitting LSP packets.
This sets LSP packet
retransmission internal.
This designates DIS election
priority of an interface.
This configures IS-IS metric
of an interface to participate
in calculation for number of
shortest IS-IS paths.
This configures IS-IS CSNP
interval in order to set
the interval between CSNP
packets.
37