Operation - Wells M4200 Owner's Manual

C. DAILY SET-UP PROCEDURES
1. Make sure the power cord is plugged into the appropriate
power supply receptacle.
2. Recommended shelf positions for quality baked products:
NO. OF PANS
OF PRODUCT
1
2
3
3. Place the ON/OFF/FAN switch in the ON position. The green POWER
ON light will glow.
4. Check oven set temperature. Press and hold the TEMP button for 5
seconds or until the screen flashes the current set temperature.
If this is not right, refer to and follow the step-by-step procedure
for "Set Temperature", page
5. If the oven set temperature is correct, press the button again to clear the
display.
6. Ensure that the door is closed. The amber HEAT light will glow, indicating that
the heaters are on.
7. Allow the oven to preheat for 30 minutes.
HINT: The product timer can be used for timing the preheat time.
8. When the amber HEAT light goes out, the oven is ready to use. From then on the amber HEAT light will
cycle on and off with the heaters (i.e. light will glow when the heaters are on).
9. Check to see that the timers are set for the correct times. If not, see "Set Timer", page 7.
D. OVEN OPERATION
1. Make sure the power cord is plugged into the appropriate power supply receptacle.
2. Place the ON/OFF/FAN switch in the ON position.
3. Verify that the time being displayed on each of the timer digital displays is correct. If not, see "Set
Timer", page 7.
4. To start a product cook timer, press the corresponding PRODUCT COOKING TIMER button once.
The digital display will brighten and a timing dot will appear in the lower right-hand corner of the display.
The timer will automatically begin to countdown. The timer display will show the time remaining in the
cook cycle.
5. When the timer reaches "00", a three-tone audible alarm will sound, and the display will blink.
6. To stop the audible alarm, or to cancel a timer operation, press the corresponding PRODUCT
COOKING TIMER button once.
The display will change to IDLE mode (low intensity), the timing indicator dot will turn off, and the audible
tone will be cancelled.
RACK POSITION
UTILIZED
5
2 & 8
2, 5 & 8
7.
9
USE THESE
RACK
POSITIONS