PRECAUTIONS:
FREQUENCY:
TOOLS:
TO BE PERFORMED BY QUALIFIED PERSONEL ONLY
1. The hinges provide the pivot for the door, allow for height adjustment and alignment so that
the door closes properly on the gasket.
2. To access the hinge adjustments:
a. Remove the prep top and oven top panel
b. Remove the bottom trim panel by removing the four screws at the ends of the panel, and
by loosening the two screws holding the bottom door gasket. The panel will then pull
straight out.
PREVENTATIVE MAINTENANCE
HINGE ADJUSTMENT
CONVECTION OVEN M4200
None
Monthly, at a Minimum; or, As Needed
Phillips (+) Screwdriver, 4"x2" Strip of 20# Paper
7/16" Nut Driver, 7/8" and 1-1/8" Wrenches
CAUTION: Exposed Electrical Circuits
Use care to avoid wiring for hotplate section during this procedure
page 1 of 2
15
PM 903.3