Wells M4200 Owner's Manual page 18

3. The door should be approximately centered between the upper and lower lips of the cabinet.
Adjust the door for height:
a. The hinge sleeve acts as a jam nut for the height adjuster.
b. The top and bottom clearances should be approximately equal. If necessary, loosen the
hinge sleeve and turn the height adjustment nut until the required clearances are
achieved.
c. Retighten the hinge sleeve.
4. Check fore-and-aft adjustment in two places on the hinge-side of the door. Use a piece of
paper (such as a dollar bill) between the inner surface of the door and the door gasket. The
paper should be definitely held, but should be able to be pulled out with just a slight drag.
5. To adjust a top or bottom hinge:
a. Loosen the holding bolts.
b. Tighten or loosen the adjusting bolt as needed to achieve the proper vertical clearance(s).
c. Retighten the holding bolts.
d. Recheck the clearances. Recheck the tightness of the bolts.
6. Reassemble the oven top, prep top and bottom trim panel. Remember to retighten the
screws for the lower gasket.
PROCEDURE IS COMPLETE
PREVENTATIVE MAINTENANCE CARD
HINGE ADJUSTMENT
CONVECTION OVEN M4200
HINGE BRACKET
DOOR PIVOT
ADJUSTING
BOLT
HINGE SLEEVE
HINGE BRACKET
HEIGHT
ADJUSTMENT
ADJUSTING
page 2 of 2
16
HOLDING
BOLTS
HOLDING
BOLTS
BOLT
WELLS MANUFACTURING COMPANY
Customer Service (775) 345-0444 Ext.502
PM 903.3
2 ERIK CIRCLE, P. O. Box 280
Verdi, NV 89439
fax: (775) 345-8238
www.wellsbloomfield.com