Latch Adjustment - Wells M4200 Owner's Manual

Wells m4200 convection oven owner's manual

Hide thumbs Also See for M4200:

Owner's manual (36 pages)

Table Of Contents

Table of Contents

PRECAUTIONS:

FREQUENCY:

TOOLS:

1. The door latch must be adjusted such that the door

will latch easily, yet remain closed and latched throughout

the cook cycle.

If the door is too tight when the oven is cold, it may pop

open as the oven reaches temperature.

2. Check adjustment in two places on the latch-side of the

door.

Use a piece of paper (such as a dollar bill) between the

inner surface of the door and the door gasket, just above

and just below the latch. The paper should be definitely

held, but should be able to be pulled out with just a slight

drag.

3. To adjust the vertical alignment, hold the striker assembly

while loosening the two screws. Move the striker assembly

as needed, but do not allow the parts of the striker to move

in relation to each other. Retighten the screws and re-check

the alignment.

BACK PLATE

4. To adjust the fore-and-aft alignment, the back plate acts as a tapered shim. Moving

STRIKER

the back plate vertically, in relation to the striker, will adjust the thickness of the striker

assembly. When properly adjusted for thickness, verify the vertical alignment and

FRONT PLATE

tighten the screws.

5. Recheck the alignment. Recheck the tightness of the screw.

PROCEEDURE IS COMPLETE

LATCH

PREVENTATIVE MAINTENANCE

CONVECTION OVEN M4200

None

Monthly, at a Minimum; or, As Needed

Phillips (+) Screwdriver, 4"x2" Strip of 20# Paper

TO BE PERFORMED BY QUALIFIED PERSONEL ONLY