Table of Contents
Advertisement
OPERATION
VENTILATOR OPERATION
1.
Press the VENTILATOR POWER switch to ON. The green
VENTILATOR POWER light will glow and the blower fan will start.
warmer is energized at all times.
During normal operation, the VENTILATOR POWER light will be
the only light glowing on the upper control panel.
PRE-FILTER and FILTER PACK for proper installation in their
vacuum switch.
is nearing the end of its service life. Replace the disposable PRE-
FILTER ELEMENT.
4.
When the amber REPLACE FILTER PACK light illuminates, the
Note: The REPLACE PRE-FILTER and REPLACE FILTER PACK
service life. The appliance will continue to operate for a period of
time after the light glows to allow continued operation through a
a reasonably short time period or they will clog and shut down
will continue to run.
will remedy the situation.
Reset the unit by turning the VENTILATOR POWER switch to
6.
A failure of incoming electrical power will cause a shut down of
the unit. After power is restored, reset the unit by turning the
suppression system is charged, and the ventilator section is operating
OFF,
13
AUTION:
OT SURFACE
Exposed surfaces can be hot
to the touch and may cause
burns.
Fig. 9 Ventilator Indicator
and Warning Lights
Advertisement
Table of Contents
