Mixer (Vocal Mode); Tone Programming (Vocal Mode) - Korg iS35 User Manual

Page 17: Mixer (Vocal mode)
[Parameters memorised in the Keyboard Set]
In this page you can program the mixing of the
VOCAL/GUITAR section (Vocal mode).
MODE ARR.PLAY
CHORD
TEMPO
Vocal volume
Page 18: Tone programming (Vocal mode)
[Parameters memorised in the Keyboard Set]
This page contains the programming of the Tone effect
selected in "Page 15: Vocal effects (1) (Vocal mode)"
(see page 74).
Note: These parameters can only be accessed if the
TONE parameter is not set on OFF in "Page 15: Vocal
effects (1) (Vocal mode)".
The Tone section is composed of an equalizer with
three fixed bands. The bands are Lo, Md, and Hi.
MODE ARR.PLAY
CHORD
TEMPO
Harmony volume
M 7
OCTAVE
PAGE
Effects send
M 7
OCTAVE
PAGE
Reference • Arrangement Play mode
Harmony
[0...127]
Level of harmonization notes.
Lead
[0...127]
Microphone level.
FxSend
[0...127]
Effect send. It corresponds to the signal level from the
VOCAL/GTR connector sent to the FX1 and FX2
effects.
Lo
[-15...0...+15]
Low frequency band. With positive values the band is
boosted (level increase), whereas with negative values
the band is cut (level reduction).
Md
[-15...0...+15]
Medium frequency band. With positive values the
band is boosted (level increase), whereas with nega-
tive values the band is cut (level reduction).
Hi
[-15...0...+15]
High frequency band. With positive values the band is
boosted (level increase), whereas with negative values
the band is cut (level reduction).
75