Korg iS35 User Manual page 217

M Modulation depth 0...99
F Feedback –99%...+99%
→ Dry:Effect balance
DRY,
B1...B99, FX
47: Delay & Rotary Speaker
This effect combines a mono delay with a mono rotary
speaker in parallel.
47: Delay/Rotary provides a mono rotary speaker that
produces a heavier tremolo than the stereo rotary
speaker (34: Rotary Speaker) effect.
Left
Right
T Delay time 0...500 ms
F Feedback –99%...+99%
Set the depth at which the phase
will be modulated. Higher set-
tings will cause the modulation
effect to be more pronounced.
With a setting of 0 there will be
no phaser effect.
Set the amount of feedback; i.e.,
the amount of the delayed signal
that will be returned to the input
of the phaser. As this value is
increased, the resonance produ-
ced by the phaser effect will be
increased. Negative values will
invert the phase of the feedback
and increase the resonance of
the effect.
Set the balance between the
direct sound (DRY) and the
sound processed by the effect
(FX). With a setting of DRY, the
effect will be turned off. With a
setting of FX, only the phaser
sound will be heard. Other set-
tings set the proportion of the
direct sound and effect sound.
P. 194.
Mix
Feedback
Delay
Rotary
Speaker
Mix
Set the basic delay length for the
delay effect.
Set the amount of feedback; i.e.,
the amount of the delayed sound
that will be returned to the input
of the delay. As this value is
increased, the number of delay
repeats will increase, and it will
take longer for the echoes to
disappear. Negative values will
invert the phase of the feedback,
causing the tone of the echo to
be harder, and less hollow-soun-
ding.
Dry:Effect balance DRY,
B1...B99, FX
A Acceleration 1...15
C
S Slow speed 1...99
F Fast speed 1...99
Dry:Effect balance DRY,
B1...B99, FX
You can use dynamic modulation to switch between
slow and fast while you play. Use a switch-type con-
troller for this purpose. I.e., even if a continuous con-
troller is moved rapidly, this will not cause the
rotational speed to follow the motion, and will not
affect the way in which the low and high speeds
switch. The rotational speed is not affected by the
speed at which the controller is moved, but will
change to the new speed at the rate specified by the
AC (acceleration) parameter.
Reference • Effects
Set the balance between the
direct sound (DRY) and the
sound processed by the effect
(FX). With a setting of DRY, the
effect will be turned off. With a
setting of FX, only the echoed
sound will be heard. Other set-
tings set the proportion of the
direct sound and effect sound.
When dynamic modulation is
used to switch the rotational
speed, this parameter sets the
time required to accelerate from
low speed to high speed (or to
decelerate from high to low
speed). Higher settings will
result in faster acceleration or
deceleration.
Set the rotational speed for
when the LFO is switched to the
slow speed. Higher settings will
produce faster rotation.
Set the rotational speed for
when the LFO is switched to the
fast speed. Higher settings will
produce faster rotation.
Set the balance between the
direct sound (DRY) and the
sound processed by the effect
(FX). With a setting of DRY, the
effect will be turned off. With a
setting of FX, only the rotary
speaker effect sound will be
heard. Other settings set the
proportion of the direct sound
and effect sound.
P. 194.
209