Korg iS35 User Manual page 109

** The KB MODE/ASSIGN parameter controls the
KEYBOARD ASSIGN and KEYBOARD MODE sec-
tions:
Option Keyboard Assign
FUL-UP1
FUL UP1&2 UPPER1, UPPER2
SP UP1&L UPPER1, LOWER
DRUM
FUL-MUTE
FUL-UP2
SP-MUTE
SP-UP1
SP-UP2
SP-UP1&2 UPPER1, UPPER2
SP-LOW
Step recording the real time track
1. Press EXIT/NO to get to Page 2 in the Backing
Sequence mode.
2. Select the KBTr track.
3. Press REC/WRITE/LYRICS and then START/
STOP. The following page will appear.
Note
Metro Step
4. Move the cursor to the parameters you wish to
modify, using the CURSOR buttons, and change
the values using the TEMPO/VALUE buttons (or
the DIAL).
5. Select the step using the buttons with the notes (or
with the TEMPO/VALUE buttons (or the DIAL))
and play the note to be entered.
6. When finished, press START/STOP to go back to
Page 2 of the Backing Sequence mode.
7. To playback the new backing sequence, go back to
Page 1 and press START/STOP.
Keyboard Mode
UPPER1 FULL
FULL
SPLIT
--- DRUM
--- FULL
UPPER2 FULL
--- SPLIT
UPPER1 SPLIT
UPPER2 SPLIT
SPLIT
LOWER SPLIT
Position
Measure
Velocity Duration
Reference • Backing Sequence mode
Note
This indicates the name of the most-recently entered
note. This parameter will appear if you have selected
track KBTr or ETr1–8.
M (Measure number)
Current measure.
Position
This indicates the position where the next event will be
entered. The number to the left of the colon (:) indi-
cates the beat within the measure. The number to the
right of the colon (:) indicates the position within the
beat, in 1/96th quarter note units.
Time signature
[1/4...16/16]
Initial time signature of the backing sequence. This
parameter will appear if you have selected track KBTr
or ETr1–8. To enter time signature changes during the
backing sequence go to "Page 8: Event edit" on
page 107.
Step
[
This specifies the length of the step by which you will
move forward each time a note is entered (or other
event). This will appear if you have selected KBTr or
ETr1–8 as the track. The value will be indicated by a
musical symbol. You can select any musical value from
(whole note) and
ened (dotted) notes (.) and triplet notes (3).
You can select the step by using either the TEMPO/
VALUE buttons (or the DIAL) or the VARIATION,
FILL, INTRO/ENDING buttons.
Velocity
[002...126, KEY]
This indicates the strength (dynamics) of the note. If
the value is KEY, the velocity with which the note was
actually played will be input. This will only appear if
you have selected KBTr or ETr1–8 as the track.
]
(32nd note), including length-
101