Using Multi-Mode Play - Korg CONCERT-800 Owner's Manual

Hide thumbs Also See for CONCERT-800:

Table of Contents

Using Multi-Mode Play

The term "multi mode" refers to the ability to play two or more "parts" simul¬

taneously.

It is often used with a sequencer or computer for automatic play.

It is also possible to manually play one of the parts at the same time on the key¬

board- (When multi mode is not selected, the unit is said to be in single mode. )

®Two out of the 0800's five timbres can be selected at a time (except PIANO &

STRINGS), and one of these two may be played on the keyboard.

®An additional timbre can be added with the Symphony orchestra module, etc-, for a

total of three, and any one of these may be played on the keyboard.

Selecting

Multi

Mode_

To automatically Enter Multi lode when Power Is Turned on-

©Connect the Concerto to the C-800 as shown below.

(Be sure to turn off power on both units first. )

©Set the mode switches on the Concerto rear panel as shown at the right. (This sets

up the Concerto

for proper operation and also informs the C-800 that it should

enter multi mode when power is turned on. )

©Turn on the power to the Concerto-

©Turn on the C-800.

(After a few seconds

delay, all the LEDs will blink three times. )

To Manually Change from Single Mode to Multi Mode.

(Not necessary to turn off power- )

★When in multi mode, pressing the MIDI/TRANSPOSE switch causes the PIANO & STRINGS

light to flash continuously.

★Pressing the PIANO & STRINGS switch

while holding down the MIDI/TRANSPOSE switch

returns the C-800 to single mode, extinguishing the light.

Table of Contents