Input Terminal Response Time; Multi-Function Output Terminal Selection - Omron 3G3MX2 User Manual

Input Terminal Response Time

A sampling time can be set individually for each of multi-function input terminals S1 to S7/EB.
Helps remove chattering and other noises. If the terminal input becomes unstable because of
chattering, etc. increase the data value.
The larger the data value is, the slower the response time. A setting range of 0 to 200 is
available, which corresponds to approx. 2 to 400 ms.
Parameter
No.
C160 to C166
Note. The response time is ignored upon power ON or reset. For example, if the power is turned on while
the FW terminal is still ON, operation resumes immediately regardless of the set value of response
time.

Multi-function Output Terminal Selection

The following functions can be allocated to Multi-function Output Terminal P1/EDM to P2
Selections (C021 to C022) and Multi-function Relay Output (MA, MB) Function Selection
(C026). Multi-function output terminals P1/EDM, P2 are open-collector output, while multi-
function relay output terminal MA, MB are relay output.
NO or NC contact can be selected individually for each output terminal using C031, C032 or
C036.
Data
00 RUN: During RUN
01 FA1: Constant speed reached
02 FA2: Set frequency min. reached
03 OL: Overload warning
04 OD: PID excessive deviation
05 AL: Alarm output
06 FA3: Set frequency only
07 OTQ: Overtorque/Undertorque
UV: Signal during undervoltage
09
10 TRQ: During torque limit
11 RNT: RUN time over
12 ONT: Power on time over
13 THM: Thermal warning
19 BRK: Brake release
20 BER: Brake error
21 ZS: 0Hz
22 DSE: Excessive speed deviation
23 POK: Position ready
SYSDRIVE MX2 Series USER'S MANUAL (3G3MX2-A@@@@)
Function name
Input Terminal 0. to 200. (× 2 ms)
Response Time Approx. 2 to 400 ms
Description
5-3 Input/Output Terminals
Data
Reference item
Signal During RUN
Frequency Arrival Signal
Overload Limit/Overload Warning
PID Function
Alarm Signal
Frequency Arrival Signal
Overtorque/undertorque
Restart Upon Momentary Power Interruption/
Undervoltage, Overvoltage/Overcurrent
Torque Limit Function
RUN/Power ON Time Exceeded
Electronic Thermal Function
Brake Control Function
0-Hz Signal (ZS)
Simple Position Control Mode
Default
Unit
setting
1. ms
Page
5-121
5-122
5-115
5-73
5-119
5-122
5-152
5-96
5-153
5-124
5-113
5-142
5-125
5-160
5-32
5