Omron 3G3MX2 User Manual page 133

Parameter
No.
A001
A201
F001
C001 to C007
*1.Only when Frequency Reference is selected to Digital Operator (A001/A201 = 02), the output
frequency can be set using F001.
If only one frequency reference method is available, data is set using A001/A201 according to
the above table.
If a frequency is set in F001, the same value is automatically set in Multi-step Speed 1
Reference 0 (A020) (F001 = A020). If Motor 2 Control is enabled (SET input = ON), the same
value set in Multi-step Speed 2 Reference 0 is set (F001 = A220).
To switch between two frequency references by combining analog current/voltage switching
based on frequency reference specification via analog input (A001/A201 = 01), and the Digital
Operator with volume 3G3AX-OP01, allocate the FV/FI terminal (16: FV/FI) to a multi-function
input. The detailed setting method is explained below. (A005: FV/FI Selection)
SYSDRIVE MX2 Series USER'S MANUAL (3G3MX2-A@@@@)
Function name
00 (Enabled when 3G3AX-OP01 is used.)
Data is set using the volume on the external
Digital Operator 3G3AX-OP01.
01
Data is set using the control circuit terminal
(analog input signal).
02
Data is set using the Digital Operator or
Remote Operator (set frequency: F001).
03
Data is set via Modbus communication
Frequency
(Modbus-RTU).
Reference
Selection 1
04
Frequency
Data is set from optional board.
Reference
06
Selection 2
Data is set using a pulse train.
Refer to "Pulse Train Frequency Input" on
page 5-82.
07
Do not set.
10
The operation result of the set frequency
operation function is defined as a frequency
reference.
Refer to "Frequency Operation Function" on
page 5-70.
Output Frequency 0.0, starting frequency to Maximum Frequency
*1
Setting 1/2
Multi-function Input 16: FV/FI (Analog input switch)
Selection
5-2 Basic Functions
Default
Data
setting
Unit
−
02
5
6.00 %
− −
5-16