Configuring Alarms
This chapter includes:
•
•
Alarm Server Settings
The HDZ Series 1080p IP PTZ dome camera supports four alarm inputs and two alarm outputs.
Ensure that the alarm connections are properly wired before configuring alarm-related settings
on the camera (see
Server Settings
You can set up the camera to send a message to an FTP, email (SMTP), or HTTP server, or to
upload images to an FTP server or email server when an alarm is triggered. You can configure
up to two servers of each type.
To enable email alarm notifications:
1.
2.
3.
4.
Alarm Server Settings, page 75
Motion Detection Settings, page 83
Connecting Alarm Inputs/Outputs on page 26
Navigate to System
Mail (see
Under SMTP, enter the server name, port, account name, password, and recipient email
address for each server.
Note
Contact your network administrator for the needed SMTP values if you do not
have them at hand.
You can select the check box for either the 1st SMTP SSL or 2nd SMTP SSL options to
enable more secure email transmission for the alarm messages.
Enter a email address to be appointed as sender in the Sender email address field.
•
Alarm Input Settings, page 78
•
Network Failure Detection
Settings, page 88
Figure
6-1).
6
for more information).
800-11873V2 - A - 07/2013
6