Table of Contents
Advertisement
100 | HDZ Series 1080p IP PTZ User Manual
4.
5.
IP Filter
You can allow or deny specific IP addresses access to the camera. When the IP filter is enabled,
the IP addresses in the list will be allowed or denied access to the camera based on the filter
setting. To enable the IP filter:
1.
2.
3.
4.
5.
Network Settings
This section contains instructions for assigning the camera a fixed IP address, setting the
camera to automatically obtain a DHCP assigned IP address, enabling PPPoE, configuring
ports, enabling IPv6 address configuration, prioritizing services, and enabling SNMP, UPnP,
and DDNS.
www.honeywell.com/security
Under Settings, in the Identity field, type the user identity associated with the client
certificate. In the Private key password field, enter the password for the user identity.
Select the Enable IEEE 802.1X check box and click Save.
Navigate to System
Security
Figure 7-7
IP Filter Settings Screen
Select the Enable IP filter check box.
Select Allow or Deny from the drop-down list, and then click Apply. The selection made
here will determine how the IP Filter treats the addresses in the Filtered IP Addresses list
(either allowing or denying access by those addresses).
In the field below the Filtered IP Addresses list box, enter an IP address you want to filter,
and then click Add.
To remove an IP address from the list, select the address in the list, and then click Delete.
Continue adding IP addresses to the Filtered IP Addresses list box, as needed.
IP Filter (see
Figure
7-7).
Advertisement
Table of Contents
