Table of Contents
Advertisement
126 | HDZ Series 1080p IP PTZ User Manual
2.
Step 4: Install the camera and bracket assembly
1.
2.
3.
Step 5: Attach the trim ring
Attach the trim ring to the ceiling support ring
by lining up the two magnets on the trim ring
with the two thumb screws on the ceiling
support ring.
www.honeywell.com/security
Tighten the pre-installed Torx screw on the camera housing to secure the camera to the
bracket frame.
Pull the loose end of the safety cable through the
opening in the ceiling and attach it to one of the
eyelets on the bracket frame.
Pull the camera cable(s) through the opening in the
ceiling and connect the cable(s) to the camera.
Insert the camera and bracket assembly into the
opening in the ceiling and attach the camera and
bracket assembly to the ceiling support ring using
the two supplied thumb screws. Use a Phillips
driver to tighten the screws.
Note
No screws are needed to attach the trim ring.
Advertisement
Table of Contents
