Table of Contents
Advertisement
24 | HDZ Series 1080p IP PTZ User Manual
Installing a Parapet/Flat Roof Mount
The HDPRM2 parapet/flat roof mount weighs 22.5 lb. (10.2 kg) and can be installed directly to
a vertical (parapet) or horizontal (flat roof) load-bearing surface. The mount has a maximum load
rating of 20.1 lb. (9.1 kg) and can be installed indoors or outdoors. The mount can withstand
winds up to 75 mph (121 km/h) when properly fastened to a support structure. See the
documentation included with the parapet mount for more information on securing the mount to
the mounting surface.
To install a roof mount:
1.
Ensure that the mounting surface can
support the combined weight of the
camera and the mount (should support at
least 28.2 lb. [12.8 kg]).
2.
Feed the cables through the mount,
leaving approximately 1 ft (0.3 m)
extending past the end of the mount.
Note
If you are using the recommended safety
cable for additional security, feed it
through the mount and attach one end to
the camera eyelet and the other end to
the building structure (see
3.
Attach the mount to the mounting surface
using as many of the mounting holes as
possible (a minimum of five fasteners on
each side of the mounting plate is
recommended).
4.
Apply sealant (not supplied) to the bottom
of the vertical pipe and around the bolt
holes to prevent water or other
contaminants from entering the mount.
5.
Screw the mount kit into the parapet/flat
roof mount.
6.
7.
www.honeywell.com/security
Figure 2-4
HDPRM2 Parapet/Flat Roof Mount Installation
Example of
Outdoor Dome
Parapet Mount
Installation
Figure
2-1).
Connect the cables to the camera (see
using a Micro SD card, install it before connecting the cables.
Note
Check that the eyelet safety cable connection is secure, and carrying all of the
load of the camera after making all cable connections.
Attach the camera to the mount kit and then tightly fix the security screw on the top of the
camera.
Feed cables through
the mount kit
Screw the mount kit
into the parapet mount
Tightly fix the screw at the top
of the camera after connecting
the three parts
Attach the
camera body to
the mount kit
Connecting the Cables on page
25). If you are
Advertisement
Table of Contents
