Table of Contents
Advertisement
66 | HDZ Series 1080p IP PTZ User Manual
To set a max gain value:
1.
2.
3.
To set the exposure mode:
1.
2.
3.
White Balance
Setting up white balance options can compensate for temperature differences with different light
sources (such as sunlight, fluorescent light, and so on), and effecting the hue of the color white
under different light sources. You can select one of the following white balance modes based
on your operating environment:
www.honeywell.com/security
Note
The gain limit can be set at the Full Auto, Shutter Priority, Iris Priority in the AE
mode. Use this setting when image signal-to-noise ratio is particularly important.
Navigate to PTZ
Camera (see
Under Exposure Mode, use the Max Gain drop-down list to select a max gain value for
the camera (from 3dB to 57dB, or Off).
Click Set to save the max gain value you have selected.
Navigate to PTZ
Camera (see
Under Exposure Mode, select one of the following:
•
Full Auto to enable full auto exposure mode. Select the Minimum Shutter Speed from
the drop-down list below the Full Auto selection.
•
Shutter Priority to enable shutter priority exposure mode. Select a shutter speed
from 1/10000 to 1/30 (NTSC), or 1/10000 to 1/25 (PAL) in the drop-down list
provided.
•
Iris Priority to enable iris priority exposure mode. Select an F-number from F1.6 to
F28 in the drop-down list provided (hint: a smaller f-number will give you a brighter
image). If Iris Priority is selected, you can select a Min Shutter Speed value from the
drop-down list provided.
•
Manual Mode to enable manual exposure mode. Select shutter (1/10000 to 1/30,
NTSC; 1/10000 to 1/25, PAL), gain (1 to 15), and iris (F1.6 to F28) values in the
corresponding drop-down lists.
Click Set to save the exposure settings that you have entered.
Figure
5-10).
Figure
5-10).
Advertisement
Table of Contents
