Using Intelligent Output Terminals
4-6-17 Excessive Speed Deviation
4-6-18 Position Ready
The inverter outputs the detection signal when the deviation between the set
speed and actual motor speed becomes less the threshold level (
function is valid when connecting the encoder feedback to the inverter.
To use this function, assign "
nals.
Option
Terminal
Code
Symbol
DSE
Excessive
speed devi-
ation
Valid for inputs:
11, 12, AL0 - AL2
Required settings:
Notes:
• The example circuit for terminal [11] drives a relay coil. Note the use of a diode to
prevent the negative-going turn-off spike generated by the coil from damaging the
inverter's output transistor.
Inverter gives out the positioning signal when positioning performance is
done.
To use this function, assign "
nals.
Refer to chapter 4 for the details of the performance.
Option
Terminal
Code
Symbol
POK
Position
ready
Valid for inputs:
11, 12, AL0 - AL2
~
Required settings:
Notes:
• The example circuit for terminal [11] drives a relay coil. Note the use of a diode to
prevent the negative-going turn-off spike generated by the coil from damaging the
inverter's output transistor.
(DSE)" to one of the intelligent output termi-
Function
State
Name
ON
Deviation between the speed
command and motor speed is less
than
OFF
Deviation between the speed
command and motor speed
exceeds
(POK)" to one of the intelligent output termi-
Function
State
Name
ON
Positioning performance is com-
pleted
OFF
Positioning performance is not
completed
Section 4-6
). This
Description
Description
239