Table of Contents
Advertisement
1.5 Usage of external Usb devices
It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
„
„
specifications, recording and multimedia functions of your receiver would not work properly.
For recording please ensure that the USB device is already formatted to FAT/FAT32. If this is not
„
„
the case, please format the USB device via your receiver. For details please refer to chapter <6.5.3
Format >.Only for the multimedia functions NTFS is supported. STRONG cannot guarantee
compatibility to all types of USB storage devices.
It is advised not to store important information on USB storage devices used with
„
„
the receiver. Always make backups of data on your USB storage device before using
it with this receiver. STRONG will not take responsibility for any loss of information or
circumstances caused by loss of information.
Please ensure that the USB device is already formatted to FAT/FAT32 or NTFS. If it is not,
„
„
please format the USB device via your PC or notebook.
2.0 YoUR RECEIvER
2.1 front panel
q button:
1.
2.
stand-by indicator: Green light in operating mode and red light in standby mode.
3.
Infrared sensor:
4.
slot for smart card: The slot is behind the front flap and only intended for service use,
2.2 Rear panel
AnT In
1.
AnT oUT
2.
3.
AUDIo (l/R)
vIDEo
4.
5.
s/PDIf
Usb
6.
hDmI
7.
8.
sCART
Power cord
9.
2.3 Remote control
1.
q
2.
!
3.
0-9
Av
4.
5.
Tv/R
6.
mEnU
7.
ExIT
4
Switches the receiver between standby (off ) and operating mode.
Receives signals from the remote control.
it won't be used during operation.
To connect to your aerial using a standard antenna cable.
To connect to your TV or additional receiver via a standard
antenna cable.
To connect to your TV or VCR, alternatively you can connect to an
amplifier or HIFI system using an RCA cable.
To connect to your TV or VCR using an RCA cable.
To connect to a digital home theatre or audio amplifier with an
audio cinch cable.
To connect your USB storage device (stick, HDD, etc.)
To connect to the HDMI input of your TV using a good quality
HDMI cable.
To connect to your TV set using a SCART cable.
To connect your receiver to the local power supply system,
supporting a voltage range of ~ 100 – 240 V 50/60 Hz.
To switch the receiver between standby and working mode
To disable/enable the audio outputs of the receiver.
In viewing mode: to switch to a channel by entering its number
In menu mode: to enter numeric values
No function
Toggles between TV and RADIO mode
To access the main menu and in menu to return to viewing mode
Exits from the menu, sub-menu or cancels actions
PART 2 • English
Fig. 1
Fig. 2
Fig. 3
Advertisement
Table of Contents
