Selecting Subtitle Language; Displaying Teletext; Using External Usb Storage Devices; Instant Recording - Strong SRT 8526 User Manual

To choose an event for watching, press ok to open the timer settings. The detailed timer setup is
described in chapter 6.4.1.
After the timer has been set up, press ExIT to return to the EPG. To close the EPG, press ExIT again.
noTE:

5.5 selecting subtitle language

Press sUb in viewing mode to display a list of available subtitle languages. Use pq to select a
language and confirm with ok. Please consider that this function supports DVB and TXT subtitles
and this selection is only displaying them temporarily. Subtitles may not be supported by every
channel/broadcaster. Additionally please adjust your preferred subtitle language as described in
chapter 6.3.1 Language Setting.

5.6 Displaying Teletext

To open the Teletext, press the gREEn (TExT) button in viewing mode. Use the 0-9 buttons to
enter the page number. The coloured buttons allow you to jump directly to the pages as indicated
in the bottom line. You can also use the pq buttons to select the next/previous page. With the tu
buttons you can select subpages. Press ExIT to close the Teletext.

5.7 Using external Usb storage devices

We strongly recommend you to carefully read and follow the specified points mentioned in chapter
1.5 Usage of external USB devices!
Further please consider these points when you use your receiver with an external USB storage
device:
Before you disconnect the USB device from the receiver, we recommend using the
„ „
Remove the USB device function which is available in several menus of your receiver. If you
have removed the USB device unintentionally, then please reconnect it to be detected
again.
Well functioning recording and playback is highly depending on the data rate supported
„ „
by the connected USB device. Especially for recording and playback of video files as well
as loading high resolution pictures, a reading speed of min. 10 - 15 MB/sec is required. As
high data rates are not supported by all types of USB devices it is necessary to ensure that
the used USB device can fulfil this requirement. Mostly such data can be found on the
website or specification sheet of the USB device manufacturer. PC Software to measure
the read/write speed of USB devices can be found via the internet as well, as an example
"HD tune" can be used.

5.8 Instant Recording

Your new receiver allows you to make an instant recording of programmes you are watching. Simply
press 4 to start the recording. To enter the duration for the recording, press 4 again.
Use 0~9 to input the recording time. For a recording duration of 45 min, just enter 45 and press ok
or for 1h 30 min, just enter 130 and press ok. During the recording a progress banner appears on
the upper left corner of your TV screen.
To open the recording info press I. To stop the recording, press 3.
*Please connect a USB storage device formatted in FAT32 with sufficient free space before you start a recording. For recording HD broadcast, we strongly recommend to use a high speed device.
WARnIng:
10
Event information will be displayed when available. Availability depends
on the broadcast.
Within Irdeto encrypted services some events may be protected or limited
and following to that recording might not be possible. This might also be
the case for recording through the analogue output on Scart to a VCR or
DVD recorder. If maturity rating is activated for a specific recording you
will have to enter the appropriate PIN Code MATURITY Rating PIN: 0000 to
record this event.
PART 2 • English