Usage Of External Usb Devices; Your Receiver; Pin-Code Default: 1234; Side Panel - Strong SRT 82 User Manual

1x remote control
„
2x AAA batteries
„
1x installation instructions
„
1x Double sided sticker
„
WARNING:

1.5 Usage of external USB devices

The unit is only compatible with USB2.0 HDD (Hard Disk Drive). USB 3.0 and/or SSD (Solid State
„
Drive) are not supported. If your device is not compatible to USB 2.0 specifications, the playback
with your receiver might not work properly or not work at all.
If you are going to use external USB HDD (Hard Disk Drive) please consider that the power
„
specifications might exceed the supported output of your receiver (5 V/500 mA). If so, please
connect your USB HDD to an according external power adapter.
„ STRONG cannot guarantee compatibility with all types of USB storage devices.
It is advised not to store important information on USB storage devices used with the receiver.
„
Always make backups of data on your USB storage device before using it with this receiver.
STRONG will not take responsibility for any loss of information or circumstances caused by loss of
information.
Please ensure that either the USB device is already formatted to NTFS or FAT32 or format the USB
„
device via your receiver. Formatting requires entering the PIN code (default 1234)
STRONG cannot guarantee the playback of all files although extensions are listed, as it depends on
„
file size, codec, bit rate and resolution.

2.0 YOUR RECEIVER

2.1 PIN-CODE DEFAULT: 1234

2.2 Side Panel

1. TV (HDMI)
2. Micro USB:
3. IR extender
4. Antenna:
The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries. If rechargeable
accumulators instead of batteries are going to be used, we recommend
using (e.g. NiMH) types with low self-discharge to ensure long time
operation of remote control.
To connect your receiver with your TV set using an HDMI
extension cable or directly.
Connector for USB devices and power from TV USB.
Point your remote control towards this sensor.
To connect to your antenna for the reception of broadcast signal,
using the IEC adapter.
Fig. 1
5