System Setup - Strong SRT 8526 User Manual

PART 2 • English
6.2.1 search setup
In the menu Search setup you can set the antenna power and the country in which you live.
Country:
Antenna Power:
6.2.2 Auto search
After selecting this menu item and pressing ok you will be asked to enter the PIN code (DEfAUlT
PIn: 0000) in order to update the current channel list. If you don't want to perform a full channel
scan you can press ExIT to cancel. After entering the PIN code (DEfAUlT PIn: 0000) the receiver
will perform an automatic channel search through all frequencies and after finishing this process it
will update the channel list. During the search process the receiver will display the progress bar, the
currently scanned frequency and the channel names. The receiver will add all new found channels
to the channel list.
6.2.3 manual search
In this menu you can search for channels on a specific frequency or channel. This menu requires
knowledge of some parameters in order to search on the correct channel/frequency in your area.
Scan mode:
If you set the scan mode By Channel, then the following is available:
Band:
Frequency channel:
If you set the scan mode By Frequency, then the following is available:
Frequency:
Band:
Signal level and quality indicators will help you ensure that you have signal on the selected
frequency channel or frequency entered, as well as to adjust the antenna, if necessary.
After you have entered the settings correctly you will need to select Search (directly above the
signal bars) and press ok. The receiver will start to search for channels and if available with your
entered parameters, they will be added to the channel list. If you don't get a satisfying result after
the search process, please contact the local service or check reliable websites/magazines if the
entered values are correct.

6.3 system setup

Press mEnU and use tu to select System Setup, then press ok. Following submenus will be
displayed: Language Setting, Output Setting, Time Setting, Auto Standby, Parental Guidance and Reset
Factory default.
Use pq to select the desired submenu and press ok or u to access.
Use the tu buttons to change the country.
If you use an antenna that can be amplified (i.e. an active indoor/
outdoor antenna) and it requires a voltage of 5 V and doesn't consume
more than 60 mA, then you can set the antenna power to On. If you use
an antenna without an amplifier or your antenna is already amplified
by an external power supply or if you use an antenna from a house
distribution system, please keep the antenna power Off.
Use tu to choose between By Channel and By Frequency.
Use tu to choose UHF (Ultra High Frequency) or VHF (Very High
Frequency).
Select a frequency channel on which you would like to search for
the channels.
Use 0-9 to enter the frequency on which you would like to search
for channels.
For the VHF frequency band commonly used 7 MHz, for UHF
frequency 8 MHz is used.
13