Disable/Enable Debug Mode; Group Identifier - Avaya one-X 9600 Series Installation And Maintenance Manual

Disable/Enable Debug Mode

Use the following procedure to turn the debug mode for the button module serial port on or off.
!
CAUTION:
A DEBUG setting of "On" disables any SBM24 Button Module connected to the
CAUTION:
module interface or any adapter plugged into Slot 2.
1. When you select DEBUG from the Craft Local Procedure Screen, the following text
displays:
Debug Mode
where, except for the 9610 for which this procedure is not applicable, the setting is the text
string associated with the current system value of NVDEBUG, defined as:
"On" if the NVDEBUG system value is "1".
"Off" if the NVDEBUG system value is "0".
2. Press Change to toggle the selected setting from On to Off or vice versa.
3. Press Save to store the new setting.
If the value changed from "On" to "Off", the telephone initiates a reset. If the value changed
from "Off" to "On" the Craft Local Procedure screen redisplays.
The telephone saves the new value.

Group Identifier

Use the following procedure to set or change the Group Identifier.
Note:
Perform this procedure only if the LAN Administrator instructs you to do so.
Note:
For more information about groups, see
1. When you select GROUP from the Craft Local Procedure Screen, the following text
displays:
Current setting:
New Setting:
where the setting is the current system value of NVGROUP.
2. Enter a valid Group value (0-999).
3. Press Save to store the new setting and redisplay the Craft Local Procedure screen.
On
The GROUP System Value
Disable/Enable Debug Mode
on page 55.
Issue 6 February 2009 43