Avaya one-X 9600 Series Installation And Maintenance Manual page 39

nnn.nnn.nnn.nnn is the current IP Address associated with the specific address
information to its left, which could be either a value previously set by a technician, or the
original value of NVIPADD if no previous change was made,
NVL2Q text string is the text string associated with the current system value of NVL2Q
where "Auto" = an NVL2Q value of "0", "On" = an NVL2Q value of "1", and "Off" = an
NVL2Q value of "2", and
dddd is the current value of NVL2QVLAN and ddd is the current value of NVVLANTEST,
respectively.
2. Use the navigation arrows to scroll to and highlight the address you want to change, then
press Change to display the change screen for that specific address value.
3. Depending on the item you selected, choose one of the following:
If you want to
Change any of the IP
Address values (Phone,
Call Server, Router,
Mask, &/or File Server)
Change the 802.1Q
value
Change the VLAN ID
value
Change the VLANTEST
value
4. Press Save to store the new setting and redisplay the Craft Local Procedure screen or
Cancel to return to the Craft Local Procedure screen without saving the value entered.
Once the new values are stored, the telephone is reset.
If a new boot program is downloaded from the HTTP server after you enter static
addressing information, you must reenter your static addressing information.
Then
Use the dialpad to enter the new IP Address. IP Addresses
have three sets of three digits followed by a period. Pressing *
following entry of three digits causes a period to be placed in
the next position, and the cursor to advance one position to the
right.
For example, to enter the IP Address 111.222.333.444, press
the 1 on the dialpad three times then press *, press the 2 on the
dialpad three times then press *, press the 3 on the dialpad
three times then press *, then press the 4 on the dialpad three
times. Proceed to the next step.
Use the Right navigation arrow to cycle through the text strings
corresponding to the NVL2Q values defined as
"Auto" if NVL2Q=0, "On" if NVL2Q=1, and "Off" if NVL2Q= 2
until the text string of the value you want to change to displays.
Proceed to the next step.
Use the dialpad to enter the new static VLAN ID of from 0 to
4094, inclusive. Proceed to the next step.
Use the dialpad to enter the new value of the DHCPOFFER
wait period of from 0 to 999, inclusive. Proceed to the next step.
Static Addressing Installation
Issue 6 February 2009 39