Avaya one-X 9600 Series Installation And Maintenance Manual page 78

Restart Scenarios
where s is the number of seconds that have elapsed since DHCP was invoked. The
message on the left appears if 802.1Q tagging is off and access to local programming
procedures is not disabled or restricted. (See
specifics.) The middle message appears if 802.1Q tagging is on and access to local
programming procedures is disabled or restricted. If the left and middle messages alternate
every two seconds, 802.1Q tagging is on. When both messages alternate, access to local
programming procedures is not disabled or restricted. Finally, the message on the right
appears if 802.1Q tagging is off and access to local programming procedures is disabled or
restricted.
The number of elapsed seconds is incremented once per second, until DHCP successfully
completes.
7. The DHCP server provides IP Addresses for the following hardware:
The IP telephone
The HTTP/HTTPS server
The TN799C or D Control-LAN (C-LAN) circuit pack on the media server
8. Using the list of gateway IP Addresses provided by the DHCP server, the telephone
performs a router check. The telephone cycles through the gateway IP Addresses with
ARPs or pings until it receives a response. When the router is located, received LLDP TLVs
are processed. Then the HTTP process starts.
9. While the IP telephone connects to the HTTP server, the telephone displays one of the
following messages:
HTTP:n ipadd
where n is the number of the IP Address obtained from the HTTP server and ipadd is the IP
Address.
!
Important:
As of Software Release 1.5, pressing * (asterisk) whenever a "* to program"
Important:
message displays or whenever the initialization process can support an interrupt
invokes the Craft Access entry procedure to allow manual settings, but only if the
PROCSTAT (local dialpad procedure status) system value is "0." The zero
PROCSTAT value provides full access to local procedures. If PROCSTAT is "1"
the Craft Access entry procedure can be invoked only when a "* to program"
message displays and only the VIEW procedure is available. For information, see
Chapter 3: Local Administrative
10. When connected, the telephone looks for an upgrade script file.
78 9600 Series IP Telephones Release 3.0 Installation and Maintenance Guide
Chapter 3: Local Administrative Options
HTTP:n ipadd
* to program
Options.
for