Printing With Crop Marks - Roland SolJet PROII SC-540 User Manual

2-7 Reloading the Media and Performing Cutting
Media Sizes Allowing Automatic Crop-mark Detection
When you are printing with crop marks, set a margin of at least 90 mm (3-9/16 in.) before the next print-start position.
You can set the margin value with the RIP you're using. For information on how to make the setting, refer to the docu-
mentation for the RIP you're using.
12.5 mm (0.5 in.)
1.5 mm (about 0.06 in.)

Printing with Crop Marks

Load media and output the data. Crop marks are automatically printed at four places.
Use your RIP to make the setting for printing crop marks. For information on how to make the setting, refer to the
documentation for the RIP you're using.
You can use BASE POINT and ALIGN POINT 1 through ALIGN POINT 3 to perform alignment automatically or
manually. For information about how to make the settings, see the following section.
Crop marks and the like drawn with computer programs cannot be used as crop marks by this machine.
54
Chapter 2 - Basic Operation
: Crop marks
90 mm (3-9/16 in.)
or more
12.5 mm (0.5 in.)
The actual size where
output is possible
12.5 mm (0.5 in.)
Cropmark
(ALIGN POINT3)
Cropmark
(ALIGN POINT1)
: Pinch rollers
Where to cut the media off
12.5 mm (0.5 in.)
1.5 mm (about 0.06 in.)
Cropmark
(ALIGN POINT2)
Cropmark
(BASE POINT)