Table of Contents
Advertisement
Incorrect cutting conditions may cause symptoms such as those described below.
If you are using a media with a strong adhesive layer, the adhesive layer may adhere to itself immediately when cut. This means
that even though the media has actually been cut, it may appear as if it has not been cut, and blade force may mistakenly be set
too high.
If a cutting test shows that the media peels easily and the blade traces on the carrier paper are optimal, then the media is being
cut. Take care not to set the blade force excessively high.
Downloading Cutting Data
Cutting is started when data is sent.
If the top menu isn't displayed, cutting doesn't start even when data is sent from the computer. If another menu screen is
displayed, press the [SETUP] key, and display the top menu.
Conditions for starting printing
• The media and blade must be already set up (with the SETUP LED lighted).
• The display must show the top menu.
2-5 Cutting
Top menu
W 1234 mm
L ----- mm
Chapter 2 - Basic Operation
51
Hide quick links:
Advertisement
Table of Contents
