Table of Contents
Advertisement
Top menu
Submenu
INK CONTROL
EMPTY MODE
PUMP UP
HEAD WASH
UNIT
FACTORY
DEFAULT
SYSTEM REPORT
ENV.MATCH
[EMPTY MODE]: When replacement of the ink cartridge becomes
necessary while printing is in progress, this setting determines whether
printing continues or pauses. This setting is used when the ink car-
tridge cannot be changed immediately during printing, such as dur-
ing unattended operation at night.
[CONT.] causes printing to continue without pause even if ink refill-
ing becomes necessary. To replace an ink cartridge, press the [PAUSE]
key to pause operation, then replace with a new cartridge. Pressing
the [PAUSE] key again resumes printing.
Printing continues with the small amount of ink remaining, so the
printed image may become faint as the ink runs out. In general, it
should possible to perform about 1 m
message appears, although the actual varies widely according to the
amount of ink needed for the particular image. Printing is continued
only for the data currently being printed. Operation stops after one
image is output.
[STOP] causes operation to pause immediately when the ink car-
tridge needs to be changed. Printing is resumed by replacing the
cartridge. Please note, however, that the colors of an image in progress
may no longer be perfectly matched if the unit is allowed to remain
paused for two or three hours before resuming printing.
[PUMP UP] : Drains ink from the printing heads.
[HEAD WASH] : This washes the printing heads with optionally
available cleaning cartridges.
—
This selects millimeters or inches as the unit of measurement for the
width displayed on the top menu after setting up the media. When
inch display is used, values are displayed to the first digit to the right
of the decimal point.
—
This returns all menu settings to their original values when shipped
from the factory.
For more about the factory defaults for the various settings, see the
"Default value" entry for each menu setting in this section.
—
This prints the current status of settings and other system information.
—
This performs automatic adjustment on the machine to obtain a state
optimized to the operating environment (temperature and humidity).
Function
2
2
(10 ft
) of printing once this
Chapter 5 - Menus and Keys
5-2 Description of Menus
Setting
Default
range
value
[EMPTY
[EMPTY
MODE]
MODE]
CONT./
STOP
STOP
mm / INCH
mm
—
—
—
—
—
—
97
Hide quick links:
Advertisement
Table of Contents
