Adjusting Manually - Roland SolJet PROII SC-540 User Manual

3-6 Making Corrections for Printing and Cutting

Adjusting Manually

Read the correction value from the test pattern printed and cut on the media. Enter the read correction value with the
operation panel, then align the printing and cutting positions.
1 Load media and install a blade, then press the
[SETUP] key.
2 Press the [MENU] key, and press the [
to make the following screen appear on the dis-
play.
3 Press the [
appear on the display.
Press the [ENTER] key to print and cut the test
4
pattern.
5 From the test pattern, read the value at the lo-
cation shown in the figure.
Chapter 3 - A Wide Variety of Operations
70
] key to make the following screen
Make sure the value
on the [FEED] side.
] key
Test pattern
Correction-value scale
+2.0 +1.5
-2.0 -1.5
Scan direction
Read the scale on which the cutting line goes over as the
correction-value .
In this figure, the value is "-0.3."
Use the same method to read the value on the [FEED] side.
The SETUP LED lights up
MENU
PRINT - CUT ADJ.
PRINT - CUT ADJ.
TEST PRINT
Make sure the value
on the [SCAN] side.
+2.0 -2.0
+1.5 -1.5
+1.0 -1.0
+0.5 -0.5
+0.0 -0.0
Scan
+1.0 +0.5 +0.0
Feed
-1.0 -0.5 -0.0
Cutting line
Cutting line
-0.5