About The Printing Or Cutting Area - Roland SolJet PROII SC-540 User Manual

7-3 About the Printing or Cutting Area

The printing or cutting area along the horizontal plane (the direction in which the carriage moves) is determined by the
position of the pinch rollers. The workable area spans the length between the two rollers, minus a margin of about 1.5 mm
(about 0.06 in.) on both sides.
If "PIECE" has been selected and media length (the distance in the X direction as shown in the figure) is 2,000 mm (78-
3/4 in.), the area is the same as when "EDGE" has been chosen.
10 mm
Pinch roller (left)
(3/8 in.)
75 mm (3 in.)
(If the material configuration is "EDGE" or "PIECE.")
When crop marks are printed, the printing or cutting area in the area shown above is reduced by an amount equal to the
size of the crop marks (12.5 mm (0.5 in.) + 12.5 mm (0.5 in.)).
12.5 mm
The area
(0.5 in.)
shown above
Pinch roller
(left)
12.5 mm
(0.5 in.)
Chapter 7 - Appendix
118
Max.: 1346 mm (53 in.)
Material
Max.: 24998 mm
(984-1/8 in.)
Approx. 1.5 mm
(about 0.06 in.)
Crop mark
Printing or cutting area
Approx. 1.5 mm
(about 0.06 in.)
* The arrows in the figure indicating the X and Y directions indicate
respectively the positive directions of the X axis and Y axis.
Printing or cutting area when crop marks are printed
Crop marks
90 mm
(about 3-9/16 in.)
10 mm
Pinch roller (right)
(3/8 in.)
75 mm (3 in.)
(If the material configuration
is "EDGE" or "PIECE.")
Printing or cutting
coordinates origin (0, 0)
The area shown above
12.5 mm
(0.5 in.)
Default area
Pinch roller (right)
12.5 mm
(0.5 in.)
Printing or cutting
coordinates origin (0, 0)
Crop mark